Choosing the wrong drill bit and wall plug is the usual reason a shelf pulls out of the wall. The bit must match the plug, and the plug must match the screw. Wall plugs are colour coded, and the table above shows each colour with its bit and screw sizes. Use it as a guide, and always check the pack, because brands differ a little.
How to read the colour code
The colours in the table are the common UK-style code used by most brands sold in South Africa. The pack states the bit size and screw range, so check it. If the plug is a different colour or an unknown brand, trust the pack over the chart.
The bit should be the same diameter as the plug. The screw must fill the plug and expand it as it goes in. A screw that is too thin leaves the plug loose, and one that is too thick can split it.
Match the bit to the material
The material decides the bit and whether you use hammer action. Tile, glass and drywall need no hammer. Brick and concrete need it. The table lists the right bit and one tip for each material.
- Know what is behind the wall. Use a detector before you drill, to avoid pipes and cables.
- Use a depth guide. Wrap tape on the bit so the hole is a little deeper than the plug and screw.
- Clear the dust. Dust at the bottom of the hole stops the plug going in fully.
Plug types and heavy loads
A plain plug suits solid brick and concrete. Hollow bricks, which are common in South African boundary walls and some older homes, need a plug that expands inside the cavity or a frame fixing. Drywall and gypsum board need hollow-wall anchors, because ordinary plugs do not grip.
For heavy loads such as wall-mounted TVs, wall cupboards or geyser brackets, use the plug and screw the maker specifies, and fix into solid masonry or a stud. If you are unsure about the wall, ask a handyman. Test a plug first: after fixing it, pull firmly on the screw before you hang anything. If the plug turns or moves, drill a fresh hole nearby and try a longer or wider plug.
When to call a handyman
Drilling near wiring, pipes or a damp wall is best left to someone with the right detector and experience. The same goes for heavy mounts where a fall could cause injury.
HandymanService.co.za does not do the work. Use the form on this page and independent handymen can send you a free quote to hang, mount or fix what you need.
